45 Cubic Gasoline Tank Semi-Trailer-manufacture,factory,supplier from China

Changing the hydraulic oil looks like a simple job, but many friends of the driver of the rear-turning semi-trailer do not know how to change it correctly. They often mix the new and old hydraulic oil, which will greatly reduce the service life of the hydraulic system. So how to change the hydraulic oil of the rear tipper semi-trailer? Are there any precautions?The traditional method of replacing hydraulic oil for rear dump semi-trailer is nothing more than extracting the hydraulic oil from the hydraulic oil tank, replacing the hydraulic oil filter element, and then adding new hydraulic oil.

When there is an electrical fault in the oil tank trailer, it is an important prerequisite for maintenance to quickly and accurately judge the fault. After a lot of practice and research for a long time, the maintenance engineers have realized that the following methods are very practical in electrical diagnosis.Observation methodIf the starter of the ofuel tanker trailer cannot be started, turn on the headlight first, observe its brightness, and judge whether the fault is caused by poor contact of the power line or battery power loss.

1. Pipeline laying and installationA. Arrange the pipeline reasonably according to the vehicle model. The long pipe shall be connected with the air storage tank of the rear relay valve. The length shall be appropriate and shall not be too loose or tight. The pipe clamp shall be locked on the thread clamp screw on the right side of the longitudinal dye. The thread clamp shall not be missed.

Semi trailers are widely used and cannot be replaced by ordinary vehicles. Almost all materials can be completed by semi trailers. Now let's take a look at the production process of semi-trailer.

First of all, the semi-trailer should do a systematic test during the running-in period to see whether the connection with the host is correct and safe and reliable, check whether there is any problem with the braking system, whether the tire pressure of the semi-trailer meets the standard, and check whether the various parts of the semi-trailer are loose, cracked and deformed.Subsequently, the load of the semi-trailer during the running-in period cannot exceed 80% of the rated load weight; During medium-speed driving, pay attention to the temperature of bearings and hubs.

Master the correct driving method of the dump semi-trailer, the dump semi-trailer in the unloading of the car is rollover or back, we usually drive the dump semi-trailer, we must master the correct driving mode, dump semi-trailer manufacturers to introduce. 1. First of all, when the dump semi-trailer starts, pay attention not to use too much throttle, clutch can not be violently lifted and put, the start must be stable. 2. Avoid some bad driving habits, such as putting your hand on the stop rod for a long time, which will affect the safety of driving and damage the gearbox.

Because the summer is too hot, people's sleep quality is usually not good, semi-trailer drivers are easy to get tired and doze off during the drive, so in the summer to ensure adequate sleep, and then try to avoid noon.

On the construction site we can often see a variety of dump semi-trailers, through these dump semi-trailers to transport sand or earth, greatly improve work efficiency, but also save costs, then let's take a look at what problems should be paid attention to when unloading the rear dump semi-trailer. Self-discharging has higher and more requirements for the site than the rear dump semi-trailer.

1. Introduction the present situationWith the improvement of the highway and its infrastructure and the rapid development of the national economy, the demand for semi-trailer with high transport efficiency is growing rapidly in recent years.Among the components of the semi-trailer, the tire is the only component of the vehicle that directly contacts the road surface.

In recent years, due to the interest trend, the semi-trailer market is mixed, and it is difficult to argue between true and false.